It’s always fun to start a new project. It can be a challenge to decide what to do next when you’re looking at a plain window. I really like to do sun mosaics, and I have a neat piece of glass that just shouts “SUN!” to me, so a few days ago I measured the middle of the window and then figured out what size sun I thought would look good there. I cut the circle down with my manual glass cutter, then smoothed the edges with my saw and grinder and glued it in place. Today it was ready to be joined by some rays.
I free-form cut the longest rays that will go to the left or right of the ball with my manual glass cutter, then smoothed the shapes with my saw and grinder.
Rays emerging from the sheet 
Smoothing edges on the saw
Once I had a few cut out, I set them in place around the ball of the sun. I’m not worried about the small gap between the ball and the rays because I plan to add a second layer of glass in a circle around the edge of the ball when I am further along with the base layer of glass.
I plan to add a lot more detail in the background, but for now I want to get the major focal points in place around the sun. I haven’t glued any of the rays in place yet, but the ball of the sun is glued down.
I think I might try to not use any more of the glass I used for the main sun / rays in the rest of the background. The decision I have to make now is whether the rest will be various shades of blue or if I will add more yellow / orange / red flame accents. Once I fill in the entire background with glass, I will coat it with resin to bring everything together. While I was working on this, I rough cut two additional circles and some extra main rays in case I decide to make some additional, similar projects from this sheet of glass. While working with the extras, I stacked them together and really liked the look of the rays overlapping. That might be the next version of this – layered rays. The pieces get heavy when I use a lot of layers, but it might be a fun experiment.